Network packet to the controller, management access is not denied.

If an IPv6 packet is destined to controller management IPv6 address and the client VLAN isĭifferent from the controller management VLAN, then the IPv6 packet is

We recommend that you configure controllers in trunk mode when you Restrictions for Configuring Distribution System PortsĬontroller configuration in access mode is not supported. This section contains the following subsections:Ī distribution system port connects the controller to a neighbor switch and serves as the data path between these two devices. controllers have two types of ports:įor a comparison of ports in different controllers, see.

Adding an Interface Group to a WLAN (CLI)Ī port is a physical entity that is used for connections on the controller platform.

Adding an Interface Group to a WLAN (GUI).

Viewing VLANs in Interface Groups (CLI).

Adding Interfaces to Interface Groups (CLI).

Adding Interfaces to Interface Groups (GUI).

Restrictions on Configuring Interface Groups.

Configuring the AP Manager Interface (CLI).

Configuring the AP-Manager Interface (GUI).

Restrictions for Configuring AP Manager Interface.

Restrictions on Configuring Dynamic Interfaces.

Prerequisites for Configuring Dynamic Interfaces.

Configuring Service-Port Interfaces Using IPv6 (CLI).

Configuring Service-Port Interface Using IPv6 (GUI).

Configuring Service-Port Interfaces Using IPv4 (CLI).

Configuring Service-Port Interfaces Using IPv4 (GUI).

Configuring the Management Interface (CLI).

Configuring the Management Interface (GUI).

Restrictions for Configuring Interfaces.

Choosing Between Link Aggregation and Multiple AP-Manager Interfaces.

Configuring Neighbor Devices to Support Link Aggregation.

Verifying Link Aggregation Settings (CLI).

Restrictions for Configuring Distribution System Ports.

Client Traffic Forwarding Configurations.

Connecting Mesh Access Points to the Network.

Steam for mac controller configuration